Reading Carbide Porosity Ratings on a Material Report
Check the test method, sample identity, rating and acceptance requirement on a carbide porosity report. Includes a report-review worksheet for buyers.
Nickel vs Cobalt Binder in Wet-Service Carbide Parts
Evaluate fluid chemistry, temperature and cleaning exposure before comparing nickel- and cobalt-bonded carbide. Includes a wet-service intake worksheet.
Brazing Carbide to Steel: Joint-Design Questions Before Ordering
Review bonded faces, insert support, material pairing and supplier responsibilities before ordering carbide for a brazed steel assembly. Includes a worksheet.
Carbide Part Traceability: Markings, Lot IDs and Inspection Reports
Connect a carbide part identifier to the right material lot, drawing revision and inspection record. Includes a fictional example and traceability worksheet.
HRA vs HV30: How to Compare Carbide Hardness Data
Read carbide hardness data without confusing HRA, HV30, typical values and acceptance limits. Includes a supplier-data comparison worksheet.
Tungsten Carbide vs PCD Wire Drawing Dies
A PCD die may contain a carbide support ring while drawing wire against diamond. Understand that construction, the different material choices and the role of wire, production run and finishing requirements when evaluating a carbide nib.
Flatness vs Parallelism on Carbide Plates: Drawing and Inspection
Separate flatness, parallelism, thickness and surface finish on carbide plates. See illustrative drawing requirements and a practical inspection worksheet.
Saw Tip Width vs Blade Kerf: Understanding Grinding Allowance
Supplied tip width, finished kerf and plate thickness describe different boundaries. See how grinding stock differs from the tooth projection that remains beyond the blade plate.
Coolant-Hole Carbide Blanks: Hole Position and Drawing Checks
Specify coolant-hole position, diameter, helix direction and end orientation before ordering a carbide tool blank. Includes a drawing-review worksheet.
Carbide vs Cermet Saw Tips: Comparing Materials for the Cut
Carbide and cermet tip families have different material structures and application strengths. Compare the workpiece, cutting interruptions, heat and wear evidence at grade level for component selection, while keeping the individual tip separate from the complete blade.